Partner for Delivering Excellence

Need Help?

Sprag Type Freewheel one-way Clutches N200

    Internal Freewheel one-way clutches

    This Series is use as

    • Backstopping

    Bore range: up to 79.3 mm.

    Nom. Transmitting torque: 1400 Nm.

Features

  • N200 series clutch is shaft mounted and pre-lubricated with special purpose grease
  • The shaft must be supported by two bearings
  • This type is particularly suitable for use in equipment (gear units) where good concentricity between Shaft & Housing is required.
  • For using this type of Clutch, Shaft must be carburized: To an Effective depth of 1.2/1.5 mm grinding.
  • Hardened to 60 HRC & Surface finish (Ra) 0.3 to 0.5 micron, Taper not to exceed 8 micron per inch (25.4 mm).
  • Concentricity: Shaft to be supported in bearings such that Shaft & Housing are concentric within 0.05 mm TIR.